forked from dan/liminix
bc588804fd
Now boots further, but then cannot open the rootfs, likely because we're not replacing the DTB with the one updated for TFTP yet ``` pci 0000:00:00.0: [0e8d:0801] type 01 class 0x060400 pci 0000:00:00.0: reg 0x10: [mem 0x00000000-0x7fffffff] pci 0000:00:00.0: reg 0x14: [mem 0x00000000-0x0000ffff] pci 0000:00:00.0: supports D1 pci 0000:00:00.0: PME# supported from D0 D1 D3hot pci 0000:00:01.0: [0e8d:0801] type 01 class 0x060400 pci 0000:00:01.0: reg 0x10: [mem 0x00000000-0x7fffffff] pci 0000:00:01.0: reg 0x14: [mem 0x00000000-0x0000ffff] pci 0000:00:01.0: supports D1 pci 0000:00:01.0: PME# supported from D0 D1 D3hot pci 0000:00:00.0: bridge configuration invalid ([bus 00-00]), reconfiguring pci 0000:00:01.0: bridge configuration invalid ([bus 00-00]), reconfiguring pci 0000:01:00.0: [14c3:7916] type 00 class 0x000280 pci 0000:01:00.0: reg 0x10: [mem 0x00000000-0x000fffff 64bit pref] pci 0000:01:00.0: reg 0x18: [mem 0x00000000-0x00003fff 64bit pref] pci 0000:01:00.0: reg 0x20: [mem 0x00000000-0x00000fff 64bit pref] pci 0000:01:00.0: supports D1 D2 pci 0000:01:00.0: PME# supported from D0 D1 D2 D3hot D3cold pci 0000:01:00.0: 2.000 Gb/s available PCIe bandwidth, limited by 2.5 GT/s PCIe x1 link at 0000:00:00.0 (capable of 4.000 Gb/s with 5.0 GT/s PCIe x1 link) pci 0000:00:00.0: PCI bridge to [bus 01-ff] pci 0000:00:00.0: bridge window [io 0x0000-0x0fff] pci 0000:00:00.0: bridge window [mem 0x00000000-0x000fffff] pci 0000:00:00.0: bridge window [mem 0x00000000-0x000fffff pref] pci_bus 0000:01: busn_res: [bus 01-ff] end is updated to 01 pci 0000:02:00.0: [14c3:7915] type 00 class 0x000280 pci 0000:02:00.0: reg 0x10: [mem 0x00000000-0x000fffff 64bit pref] pci 0000:02:00.0: reg 0x18: [mem 0x00000000-0x00003fff 64bit pref] pci 0000:02:00.0: reg 0x20: [mem 0x00000000-0x00000fff 64bit pref] pci 0000:02:00.0: supports D1 D2 pci 0000:02:00.0: PME# supported from D0 D1 D2 D3hot D3cold pci 0000:02:00.0: 2.000 Gb/s available PCIe bandwidth, limited by 2.5 GT/s PCIe x1 link at 0000:00:01.0 (capable of 4.000 Gb/s with 5.0 GT/s PCIe x1 link) pci 0000:00:01.0: PCI bridge to [bus 02-ff] pci 0000:00:01.0: bridge window [io 0x0000-0x0fff] pci 0000:00:01.0: bridge window [mem 0x00000000-0x000fffff] pci 0000:00:01.0: bridge window [mem 0x00000000-0x000fffff pref] pci_bus 0000:02: busn_res: [bus 02-ff] end is updated to 02 pci 0000:00:00.0: BAR 0: no space for [mem size 0x80000000] pci 0000:00:00.0: BAR 0: failed to assign [mem size 0x80000000] pci 0000:00:01.0: BAR 0: no space for [mem size 0x80000000] pci 0000:00:01.0: BAR 0: failed to assign [mem size 0x80000000] pci 0000:00:00.0: BAR 8: assigned [mem 0x60000000-0x600fffff] pci 0000:00:00.0: BAR 9: assigned [mem 0x60100000-0x602fffff pref] pci 0000:00:01.0: BAR 8: assigned [mem 0x60300000-0x603fffff] pci 0000:00:01.0: BAR 9: assigned [mem 0x60400000-0x605fffff pref] pci 0000:00:00.0: BAR 1: assigned [mem 0x60600000-0x6060ffff] pci 0000:00:01.0: BAR 1: assigned [mem 0x60610000-0x6061ffff] pci 0000:00:00.0: BAR 7: assigned [io 0x0000-0x0fff] pci 0000:00:01.0: BAR 7: assigned [io 0x1000-0x1fff] pci 0000:01:00.0: BAR 0: assigned [mem 0x60100000-0x601fffff 64bit pref] pci 0000:01:00.0: BAR 2: assigned [mem 0x60200000-0x60203fff 64bit pref] pci 0000:01:00.0: BAR 4: assigned [mem 0x60204000-0x60204fff 64bit pref] pci 0000:00:00.0: PCI bridge to [bus 01] pci 0000:00:00.0: bridge window [io 0x0000-0x0fff] pci 0000:00:00.0: bridge window [mem 0x60000000-0x600fffff] pci 0000:00:00.0: bridge window [mem 0x60100000-0x602fffff pref] pci 0000:02:00.0: BAR 0: assigned [mem 0x60400000-0x604fffff 64bit pref] pci 0000:02:00.0: BAR 2: assigned [mem 0x60500000-0x60503fff 64bit pref] pci 0000:02:00.0: BAR 4: assigned [mem 0x60504000-0x60504fff 64bit pref] pci 0000:00:01.0: PCI bridge to [bus 02] pci 0000:00:01.0: bridge window [io 0x1000-0x1fff] pci 0000:00:01.0: bridge window [mem 0x60300000-0x603fffff] pci 0000:00:01.0: bridge window [mem 0x60400000-0x605fffff pref] Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled 1e000c00.uartlite: ttyS0 at MMIO 0x1e000c00 (irq = 19, base_baud = 3125000) is a 16550A spi-mt7621 1e000b00.spi: sys_freq: 220000000 spi-nor spi0.0: en25qh128 (16384 Kbytes) 5 fixed-partitions partitions found on MTD device spi0.0 OF: Bad cell count for /palmbus@1e000000/spi@b00/flash@0/partitions OF: Bad cell count for /palmbus@1e000000/spi@b00/flash@0/partitions OF: Bad cell count for /palmbus@1e000000/spi@b00/flash@0/partitions OF: Bad cell count for /palmbus@1e000000/spi@b00/flash@0/partitions Creating 5 MTD partitions on "spi0.0": 0x000000000000-0x000000040000 : "u-boot" 0x000000040000-0x000000fa0000 : "firmware" 2 uimage-fw partitions found on MTD device firmware Creating 2 MTD partitions on "firmware": 0x000000000000-0x000000400000 : "kernel" 0x000000400000-0x000000f60000 : "rootfs" mtd: setting mtd3 (rootfs) as root device 0x000000fa0000-0x000000fb0000 : "config" 0x000000fb0000-0x000000ff0000 : "tplink" 0x000000ff0000-0x000001000000 : "radio" mt7530-mdio mdio-bus:1f: MT7530 adapts as multi-chip module mtk_soc_eth 1e100000.ethernet eth0: mediatek frame engine at 0xbe100000, irq 21 mtk_soc_eth 1e100000.ethernet wan: mediatek frame engine at 0xbe100000, irq 21 i2c_dev: i2c /dev entries driver NET: Registered PF_INET6 protocol family Segment Routing with IPv6 In-situ OAM (IOAM) with IPv6 sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver NET: Registered PF_PACKET protocol family 8021q: 802.1Q VLAN Support v1.8 Loading compiled-in X.509 certificates Loaded X.509 cert 'Build time autogenerated kernel key: 1305e7c8df691fbef7a37c303deca27 c3e469edb' Problem parsing in-kernel X.509 certificate list mt7530-mdio mdio-bus:1f: MT7530 adapts as multi-chip module mt7530-mdio mdio-bus:1f: configuring for fixed/rgmii link mode mt7530-mdio mdio-bus:1f: Link is Up - 1Gbps/Full - flow control rx/tx mt7530-mdio mdio-bus:1f lan1 (uninitialized): PHY [mt7530-0:00] driver [MediaTek MT7530 PHY] (irq=23) mt7530-mdio mdio-bus:1f lan2 (uninitialized): PHY [mt7530-0:01] driver [MediaTek MT7530 PHY] (irq=24) mt7530-mdio mdio-bus:1f lan3 (uninitialized): PHY [mt7530-0:02] driver [MediaTek MT7530 PHY] (irq=25) mt7530-mdio mdio-bus:1f lan4 (uninitialized): PHY [mt7530-0:03] driver [MediaTek MT7530 PHY] (irq=26) DSA: tree 0 setup Warning: unable to open an initial console. ubi0:liminix: Can't open blockdev VFS: Cannot open root device "ubi0:liminix" or unknown-block(31,3): error -2 Please append a correct "root=" boot option; here are the available partitions: 1f00 256 mtdblock0 (driver?) 1f01 15744 mtdblock1 (driver?) 1f02 4096 mtdblock2 (driver?) 1f03 11648 mtdblock3 (driver?) 1f04 64 mtdblock4 (driver?) 1f05 256 mtdblock5 (driver?) 1f06 64 mtdblock6 (driver?) Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,3) Rebooting in 10 seconds.. ``` |
||
|---|---|---|
| .. | ||
| arch | ||
| bridge | ||
| dhcp6c | ||
| dnsmasq | ||
| firewall | ||
| hostapd | ||
| mount | ||
| network | ||
| ntp | ||
| outputs | ||
| ppp | ||
| s6 | ||
| schnapps | ||
| ssh | ||
| vlan | ||
| watchdog | ||
| all-modules.nix | ||
| base.nix | ||
| busybox.nix | ||
| hardware.nix | ||
| hostname.nix | ||
| kernel.nix | ||
| outputs.nix | ||
| ramdisk.nix | ||
| squashfs.nix | ||
| usb.nix | ||
| users.nix | ||
| wlan.nix | ||