liminix

commit 0f57ae2a325e15635eab2513ee3b610f1614bc65
parent 2d05695d993325638ec6acfaa3067476b3b663d3
Author: Daniel Barlow <dan@telent.net>
Date:   Sun,  9 Jul 2023 15:18:19 +0100

fix section order

Diffstat:
M
doc/user.rst
 | 
37
+++++++++++++++++++------------------

1 file changed, 19 insertions(+), 18 deletions(-)
diff --git a/doc/user.rst b/doc/user.rst
@@ -157,23 +157,6 @@ works we can flash the image - and if it doesn't work we can reboot
 the device again and it will boot from the old image.
 
 
-Flashing from OpenWrt (not currently advised!)
-~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-
-.. CAUTION:: At your own risk! This may in some circumstances lead to
-             bricking the device: we think this flash method is currently
-	     incompatible with use of a writeable (jffs2) filesystem.
-
-If your device is running OpenWrt then it probably has the
-:command:`mtd` command installed. After transferring the image onto the
-device using e.g. :command:`ssh`,  you can run it as follows:
-
-.. code-block:: console
-
-   mtd -r write /tmp/firmware.bin firmware
-
-For more information, please see the `OpenWrt manual <https://openwrt.org/docs/guide-user/installation/sysupgrade.cli>`_ which may also contain (hardware-dependent) instructions on how to flash an image using the vendor firmware - perhaps even from a web interface.
-
 
 Building the RAM-based image
 ............................
@@ -258,10 +241,28 @@ crash in surprising ways.
 
 
 
+Flashing from OpenWrt (not currently advised!)
+~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
+
+.. CAUTION:: At your own risk! This will (at least in some
+             circumstances) lead to bricking the device: we think this
+             flash method is currently incompatible with use of a
+             writeable (jffs2) filesystem.
+
+If your device is running OpenWrt then it probably has the
+:command:`mtd` command installed. After transferring the image onto the
+device using e.g. :command:`ssh`,  you can run it as follows:
+
+.. code-block:: console
+
+   mtd -r write /tmp/firmware.bin firmware
+
+For more information, please see the `OpenWrt manual <https://openwrt.org/docs/guide-user/installation/sysupgrade.cli>`_ which may also contain (hardware-dependent) instructions on how to flash an image using the vendor firmware - perhaps even from a web interface.
+
+
 Updating an installed system (JFFS2)
 ************************************
 
-
 Adding packages
 ===============